Camera & Receiver Layout, Installation

Camera & Receiver Layout

Back side

Installation

Hardware Set Up

Camera Parts

1.Camera Lens

2.IR LED

3.Antenna

4.Power Jack

5.Camera Stand

6.1 CDS

7.Microphone

8.Cam Pair

9.Power adaptor

10.Power LED

11.U holder / U holder screw

12.T- bolt

13.Sunshield

Pairing Cameras

Pairing Camera(s)

This function is available for multi-camera users

It is highly recommended to pair the camera before hardware installation.

Before pairing the camera, make sure camera is power ON, camera status indicators shown:

A. Simply pair the camera by selecting the desired channel in the OSD menu of the existing receiver (not included).

B. Only assign one camera to one channel. Channel memory will be overwritten if the next camera is assigned to the same channel.

C. Pairing new camera to channel 3, settings as shown:

D. Press (Pair).

E. System will count down within 60 seconds, system message as shown:

F. Within 10 seconds, press the Pair Key on the back of camera.

Camera Assembly / Adjustment

A. Loosen U holder screws; slide the sunshield to ideal position. B. U bracket can be installed on camera top side for ceiling mount. C. Secure U holder with screws when done.

D. Adjust camera for proper view angle. Secure the stand with T-bolt when done.

Camera Wall / Ceiling Mounting A. Secure camera stand to the wall B. Secure camera U bracket to the

stand.

C. Adjust proper view angle then secure the joint with T-bolt.

Connect Antenna & Power Adapter A. Secure Antenna to the camera B. Connect the Power Adapter included in this pack to the camera C. Plug in Power Adapter to power

point

G. Once pairing completed, camera and receiver status indicators appear as shown