Camera Features

 

1.

Omni-directional Antenna

1

2.

Infra-red LEDs

 

3.Detachable Camera Stand
4.Microphone (enclosed in socket)
5.Power Cable & DC Power

2

Changing the Channel on the Night Hawk Camera

The Night Hawk Cameras can be switched to any of four frequencies to assist in avoiding interference. Please see the illustration below for frequency settings. Unscrew the front of the camera case to gain access to the channel switch. To change the frequency/channel on the receiver, press the SEL button on top of the receiver to cycle through the channels. You can also switch the Loop/Normal switch to Loop, which will allow the receiver to switch through all four channels automatically. The lit LED indicates which channel is currently selected.

3

4

5

Receiver Features

Front view of Switch Block (note the numbers 1 & 2 indicate the left side of the switch)

By changing these switch settings, the frequency that the Camera transmits on changes. Once you have set the channel on the Camera, select the same channel on the receiver. If you experience interference try a different channel.

Do not set two Cameras to the same channel or they will interfere with each others signal.

Channel & Frequency settings

1

 

 

 

 

 

 

Channel 1

 

 

 

 

 

 

 

 

 

 

 

Both switches Right

2

 

 

 

 

 

 

 

 

 

 

 

 

2414MHz

1

 

 

 

 

 

 

Channel 2

 

 

 

 

 

 

 

 

 

 

 

 

2

 

 

 

 

 

 

Top Left & Bottom Right

 

 

 

 

 

 

2432MHz

 

 

 

 

 

 

 

1

 

 

 

 

 

 

Channel 3

 

 

 

 

 

 

2

 

 

 

 

 

 

Top Right & Bottom Left

 

 

 

 

 

 

 

2450MHz

1

 

 

 

 

 

 

Channel 4

 

 

 

 

 

 

 

 

 

 

 

 

2

 

 

 

 

 

 

Both switches Left

 

 

 

 

 

 

 

 

 

 

 

 

2468MHz

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Active

Channel

Leds

Channel

SelectorButton

CH1 CH2 CH3 CH4 SEL

External antenna

Monitor or TV

Receiver

To Audio and

Video IN

 

 

Audio / Video Out

 

Receiver

 

Power Adaptor

 

DC Socket

 

Loop / Normal Switch

Important Information About This Product

•Best Results are achieved where there is a clear “line of sight” between the Camera/Transmitter and Receiver.

•Interference from certain electronic equipment or the moving human body can also affect the range obtainable.

•Please test all devices before final installation because transmission quality can often be improved by moving the components slightly.

•To avoid the risk of damage to Night Hawk Camera Pack, use only the supplied power adaptors.

•Beware of humid locations. Water droplets or spray may damage the receiver unit. If condensation does occur, do not use the equipment until it has dried out.

•Do not cut the DC power cable of the Night Watch Camera to fit with another power source. This may result in damage to the Night Watch Camera & any unauthorised modifications will void your warranty.

IMPORTANT: Due to the power consumption requirements of this product, we highly recommend the use of a 9 volt battery only for short term portable use.

4

5