| Camera Features |
|
|
| |
|
|
|
|
| |
1. |
|
| 1 |
| |
|
|
|
|
| |
2. |
|
|
| ||
|
|
| |||
3. | Detachable Camera Stand |
|
|
| |
4. | Microphone (enclosed in socket) |
|
|
| |
5. Power Cable & DC Power Socket |
|
| 2 | ||
|
| ||||
Changing The Channel On The Night Hawk Camera
The Night Hawk Cameras can be switched to any of four frequencies to assist in avoiding interference. Please see the illustration below for frequency settings. Unscrew the front of the camera case to gain access to the channel switch. To change the frequency/channel on the receiver, press the button on top of the receiver to cycle through the channels. You can also press the button on the remote.
3 |
4
5
Receiver Features
Front view of Switch Block (note the numbers 1 & 2 indicate the left side of the switch)
Channel & Frequency settings
1 |
|
|
|
| Channel 1 |
2 |
|
|
|
| Both switches Right |
|
|
|
| 2414MHz | |
|
|
|
|
| |
1 |
|
|
|
| Channel 2 |
|
|
|
| ||
2 |
|
|
|
| Top Left & Bottom Right |
|
|
|
| 2432MHz | |
|
|
|
|
| |
1 |
|
|
|
| Channel 3 |
|
|
|
| ||
|
|
|
| ||
2 |
|
|
|
| Top Right & Bottom Left |
|
|
|
| ||
|
|
|
|
|
1. | Directional Antenna |
2. | Channel Selector Button |
3. | IR Remote Receiver window and |
| Channel Display. |
4. | DC Power jack |
1
By changing these switch settings, the frequency that the Camera transmits on changes. Once you have set the channel on the Camera, select the same channel on the receiver. If you experience interference try a different channel.
Do not set both Cameras to the same channel or they will interfere with each others signal.
|
|
|
| 2450MHz |
|
|
|
| |
1 |
|
|
| Channel 4 |
|
|
| ||
|
|
| ||
2 |
|
|
| Both switches Left |
|
|
| ||
|
|
| 2468MHz | |
|
|
|
| |
|
|
|
|
5. | Video Out jack |
6. | Audio Out (L) jack |
7. | Audio Out (R) jack |
8. | IR Remote Control |
9. ON/OFF Switch | |
2
3
9
8
4
5
6
7
Important Information About This Product
•DUE TO GOVERNMENT REGULATIONS RELATING TO THE USE OF COVERT LISTENING DEVICES IN SOME COUNTRIES, YOU SHOULD CONSULT YOUR LOCAL COUNTRY, STATE, COUNTY OR TERRITORY REGULATIONS FOR RESTRICTIONS OR CONDITIONS OF THE USE OF SECURITY CAMERAS WITH AUDIO CAPABILITIES
•Best Results are achieved where there is a clear “line of sight” between the Camera/Transmitter and Receiver.
•Interference from certain electronic equipment or the moving human body can also affect the range obtainable.
•Please test all devices before final installation because transmission quality can often be improved by moving the components slightly.
•To avoid the risk of damage to Night Hawk Camera Pack, use only the supplied power adaptors.
Beware of humid locations. Water droplets or spray may damage the receiver unit. If condensation does occur, do not use the equipment until it has dried out.
Do not cut the DC power cable of the Night Watch Camera to fit with another power source. This may result in damage to the Night Watch Camera & any unauthorised modifications will void your warranty.
4
5