INTRODUCTION
5Attaching a Wall Mount Bracket (sold separately)
The following is a description of the method for attaching a wall mount to this unit.
When performing this operation, refer to the instruction manual included with the wall mount kit.
#CAUTION
•Any damage caused by incorrectly attempting to mount this unit is not covered under the terms of the manufacturers warranty.
•This unit may be used only with VMFb manufactured by CSAV.
•Use with other wall mounts may result in instability causing possible injury.
You need the following wall mount kit for this unit. Vision Mount LCD Mounts
Model number: VMFb
For more information, please visit CSAV website at www.csavinc.com
2
* 1 and 2 indicate the position of the screw holes on this unit.
1 
1 Turn this unit over and place it
Place this unit in a way so that the stand hangs over the edge of the table.
rear of this unit
1
stand
4 Attach this unit to the wall.
Note:
•Refer to the instruction manual included with the wall mount kit when securing this unit to the wall.
Note:
•Make sure to use a table which can support the weight of this unit and is larger than this unit.
•Make sure the table is in a stable location.
2 Remove the stand from this unit.
Unscrew the M4 screws indicated by 1 and remove the stand. Please be careful with the unit after you remove the stand.
Note:
•The M4 screws and stand you have removed are necessary for reattachment at a later date. Make sure to keep them in a safe place.
3 Attach the monitor plate to this unit using the 4 bolts included with the wall mount kit.
You do not need to use the lock washers for mounting this unit.
Note:
•Only use the screw holes indicated by 2 for mounting this unit.
•For instructions on how to attach the monitor plate, refer to the instruction manual included with the wall mount kit.
8
*If you want to attach the stand of this unit again, insert the stand slowly as illustrated below and drive M4 screws in the 4 threaded holes ( 1 ).
1
EN
