Symbol Technologies LS2100 Setting Up the LS 2100

1-3

Setting Up the LS 2100

Setting Up the LS 2100

Installing the Cable

Insert the cable into the receptacle on the bottom of the scanner, as shown below:

Figure 1-2. Installing the Cable

Switching Cables

Different cables are required for different hosts. To change the scanner cable:

1. Press the tab on the cable with a small screwdriver.

2. Pull the cable out of the receptacle on the bottom of the scanner.

Contents

Main Page Page Page iii Contents Chapter . About This Guide Chapter 1. Setting Up the LS 2100 Chapter 2. Scanning with the LS 2100 Chapter 3. Maintenance and Specifications Page v About This Guide Notational Conventions " " " Related Publications Service Information Symbol Support Center -vii About This Guide Warranty viii Warranty Coverage and Procedure General Chapter 1 Setting Up the LS 2100 Audience Unpacking Setting Up the LS 2100 Connecting to a Host Chapter 2 Scanning with the LS 2100 Scanning with the LS 2100 Aiming the Scanner What Does The Beep Mean? Page Chapter 3 Maintenance and Specifications Maintenance Troubleshooting Accessories Standard Accessories: Cables 3-3 Optional Accessories Technical Specifications Page 3-5 LS 2100 Signal Descriptions Page Glossary-1 Glossary Glossary-2 Glossary-3 Glossary Glossary-4 Glossary-5 Glossary Glossary-6 Tell Us What You Think...