6

PDT 8100 Series

Getting Started

Before you can use your PDT 8100, perform these basic setup

procedures:

• Install the antenna packaged with the terminal by screwing it

into the antenna receptacle on the top of the terminal

(PDT 8133/8137 only).

• Install the SIM card (PDT 8137 only).

• Insert the Compact Flash card (optional).

• Install and charge the battery.

• Start the PDT 81xx.

• Initiate the network connection (PDT 813x/814x only).

Installing the SIM Card (PDT 8137 Only)

1.

Slide the
latches on the
battery door up
and lift the
battery door
away from the
PDT 8137. If
the battery is
installed,
remove it.
2. Remove the flash card cover
at the top of the battery
compartment by pulling the top
out, and lifting the cover up.
3. Slide the metal
clip on the SIM
cardholder door
to the right to
release the SIM
cardholder.
4. Lift the
cardholder door to
an upright position
5. Insert the card
between the
cardholder body
and the metal clip;
be sure the
beveled corner of
the SIM card is on
the top right.
6. Close the
cardholder door
(with the contact
area of the card
facing down).
7. Slide the metal
clip to the left to
lock it in place.
8. Replace the
flash card cover.
9. Reinsert the
battery and battery
door (see Installing
the Battery on
page 8).
SIM Card
Contact Area