20
PPT 2800 Series
• If you have installed additional applications on your PPT
2800 terminal, remove them to recover memory. Select
Start, then Settings, and select the System tab. Tap Re-
move Programs, select the unused program and tap Re-
move.
Beamed data does not transmit:
• Confirm that the PPT 2800 terminals are 5” apart, and there
is a clear path between the two devices.
• Adjust the room lighting or move to a different location.
When receiving beamed data an out of memory message
appears:
• Your PPT 2800 terminal requires at least twice th e amount of
memory available as the data you are receiving. For exam-
ple, if you are receiving a 30K application, you must have at
least 60K free.
Your PPT 2800 unit does not accept scan input:
• Verify that the unit is loaded with a scanning application. See
your System Administrator.
• Be sure the symbol is not defaced.
• Be sure you are within proper scanning range.
• Be sure the terminal is programmed to accept the type of bar
code you are scanning.
• If you are expecting a beep on a good decode and don’t hear
one, check that the application is set to generate a beep on
good decode.
• If the scanner stops emitting a laser beam when you press
the trigger, check your battery level. When the battery is low ,
the scanner shuts off before the terminal notifies you of the
low battery condition.
Note: If the scanner is still not reading symbols, contact your
distributor or Symbol Technologies.