Symphonic SC313E owner manual Preparation for USE, ANTENNA/CABLE Connections

PREPARATION FOR USE

ANTENNA/CABLE CONNECTIONS

Plug the incoming cable into the ANT. jack on the rear of the unit.

If your cable service supplies you with a converter box or if you use a satellite system, connect the box with this unit as shown below.

Cable	or	Antenna
TV signal

Incoming cable from home Antenna /

Cable Company (No Cable Box)

OR	Cable Box or
	Satellite Box*
	OUT
	IN

Rear of the unit

ANT.

Incoming cable from Cable Company or Satellite Antenna

*NOTE (DO NOT DISCONNECT FROM BOX) Some cable TV systems use scrambled signals and require a special converter to receive these channels. Consult your local cable company.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.

NOTE:

Before plugging the antenna into the ANT. jack of the unit, check that the pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin into the ANT. jack of the unit.

Bent pin
Cable Plug
(Needs to be	(Straight pin)
straightened)

Rod Antenna Connection:

You can use the Rod Antenna	Rod Antenna
	(Supplied)
(supplied) if incoming cable
is not available.

ANT.

For your safety and to avoid damages to the unit, unplug the antenna cable from the ANT. jack before moving the unit.

- 9 - EN