2. Warnings and safety instructions
Operator Safety
•Always wear a safety face shield or goggles.
•Gloves should be used when sharpening chain.
•Always wear safety protective equipment such as jacket, trousers, gloves, boots with steel toe-caps and non-slip soles whenever you use a chain saw. For working in trees the safety boots must be suitable for climbing techniques. Do not wear loose clothing, jewelry, short pants, sandals or go barefoot. Secure hair so it is above shoulder length.
•Do not operate that tool when you are tired, ill or under the influence of alcohol, drugs or medication.
•Never let a child or inexperienced person operate the machine.
•Wear hearing protection.
•Never start or run the engine inside a closed room or building. Breathing exhaust fumes can kill.
•Keep handles free of oil and fuel.
•Keep hands away from cutting equipment.
•Do not grab or hold the unit by the cutting equipment.
•When the unit is turned off, make sure the cutting attachment has stopped before the unit is set down.
•When operation is prolonged, take a break from time to time so that you may avoid possible white-finger disease which is caused by vibration.
•The operator must obey the local regulations of cutting area.
Unit/Machine Safety
•Inspect the entire unit/machine before each use. Replace damaged parts. Check for fuel leaks and make sure all fasteners are in place and securely tightened,
•Replace parts that are cracked, chipped or damaged in any way before using the unit/machine.
•Make sure the safety guard is properly attached.
•Keep others away when making carburetor adjustments.
•Use only accessories as recommended for this unit/machine by the manufacturer.
•Never let the chain strike any obstacle.
If the chain makes contact, the machine should be stopped and checked carefully.
•Make sure the automatic oiler is working.
Keep the oil tank filled with clean oil. Never let chain run dry on the bar.
•All chainsaw service, other than the items listed in the operator's/owner's manual, should be performed by competent chainsaw service personnel. (For example, if improper tools are used to remove the flywheel or if an improper tools is used to hold the flywheel in order to remove the clutch, structural damage to the
flywheel could occur and could subsequently cause the flywheel to burst.)
WARNING!
Never modify the unit/machine in any way.
Do not use your unit/machine for any job except that for which it is intended.
WARNING!
Never use chain saw without any safety equipment or that has faulty safety equipment. It could result in serious personal injury.
WARNING!
Using guide bar/chain other than recommended by the manufacturer which are not approved, could result in a high risk of personal accidents or injury.
Fuel Safety
•Mix and pour fuel outdoors and where there are no sparks or flames.
•Use a container approved for fuel.
•Do not smoke or allow smoking near fuel or the unit/machine or while using the unit/machine.
•Wipe up all fuel spills before starting engine.
•Move at least 3 m (10 ft.) away from fueling site before starting engine.
•Stop engine before removing fuel cap.
•Empty the fuel tank before storing the unit/machine. It is recommended that the fuel be emptied after each use. If fuel is left in the tank, store so fuel will not leak.
•Store unit/machine and fuel in area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc.
WARNING!
Anti-vibration systems do not guarantee that you will not sustain white-finger disease or carpel tunnel syndrome. Therefore, continual and regular users should monitor closely the condition of their hands and fingers. If any of the above symptoms appear, seek medical advice immediately.
Cutting Safety
•Do not cut any material other than wood or wooden objects.
•For respiratory protection, wear an aerosol protection mask when cutting the wood after insecticide has been applied.
•Keep others including children, animals, bystanders and helpers outside the hazard zone. Stop the engine immediately if you are approached.
•Hold the unit/machine firmly with both hands.
•Keep firm footing and balance. Do not over-reach.
•Keep all parts of your body away from the muffler and cutting attachment when the engine is running.
•Keep Bar/Chain below waist level.
•Before felling a tree, the operator must be accustomed to the sawing techniques of the chain saw.
•Be sure to pre-plan a safe exit from a falling tree.
•While cutting, hold saw firmly with both hands with thumb firmly locked around front handle, and stand with feet well balanced and your body balanced.
•Stand to the side of the saw when cutting never directly behind it.
•Always keep the spiked bumper face to a tree, because the chain may suddenly be drawn into a tree.
•Be alert against kickback (when saw kicks up and back at operator). Never cut with the nose of the bar.
Maintenance safety
•Maintain the unit/machine according to recommended procedures.
•Disconnect the spark plug before performing maintenance except for carburetor adjustments.
•Keep others away when making carburetor adjustments.
•Use only genuine Tanaka replacement parts as recommended by the
manufacturer.
WARNING!
Improper maintenance could result in serious engine damage or in serious personal injury.
Transport and storage
•Carry the unit/machine by hand with the engine stopped and the muffler away from your body.
•Allow the engine to cool, empty the fuel tank, and secure the unit/machine before storing or transporting in a vehicle.
•Empty the fuel tank before storing the unit/machine. It is recommended that the fuel be emptied after each use. If fuel is left in the tank, store so fuel will not leak.
•Store unit/machine out of the reach of children.
•Clean the unit carefully and store it in a dry place.
•Make sure engine switch is off when transporting or storing.
•When transporting in a vehicle, cover chain with chain cover.
If situations occur which are not covered in this manual, take care and use good judgement.
Contact your dealer if you need assistance.
Pay special attention to statements preceded by the following words:
WARNING!
Indicates a strong possibility of severe personal injury or loss of life, if instructions are not followed.
CAUTION!
Indicates a possibility of personal injury or equipment damage, if instructions are not followed.
NOTE!
Helpful information for correct function and use.
