16
3 General Use Wake up the system
When the system is not in use, it is in standby mode and the screen is black. This is to help
protect the monitor display. Wake up the system by picking up the remote control. An incoming
call or pressing any key on the remote control will also wake up the system.
If the system does not respond:
Make sure that the system is switched on by using the On/Off switch located at the rear
of the Codec.
Verify that your monitor is switched on. This is normally done by pushing the power
button on the front of the monitor depending on monitor type. Please reference the user
guide for the monitor that was shipped with your system.