TANDBERG TT1282 2.5 Connecting the Receiver to the Power Supply

Type of Connector Description

ASI/HDSDI OUT 1 A 75 W BNC connector provides either an MPEG

transport stream output interface or serial digital video

output. ASI or HDSDI output format is selectable via the

front panel.

ASI/HDSDI OUT 2 A 75 W BNC connector provides either an MPEG

transport stream output interface or serial digital video

output. ASI or HDSDI output format is selectable via the

front panel.

ASI/SMPTE 310 IN A 75 W BNC connector prov ides an MPEG transport

stream input interface. ASI or SSI (SMPTE 310) input

format is selectable via the front panel.

10/100BaseT An 8-way RJ-45 connector provides a 10/100BaseT

Ethernet interface for external control and monitor ing .

Also optionally provides a High Speed Ethernet data

output

Alarm Relay If required, connect an external status monitoring device

to the Alarm connector. A 9-way, D-type male connector

provides an alarm relay interface which can be used to

send a signal to remote equipment.

RS-232/RS-422

Data Out RS-232 data is available on the Base Board.

Technical Earth Connect the Receiver's Technical earth to a suitable

point.

2.5 Connecting the Receiver to the Power Supply

Refer to the Reference Guide for all power supply, fuse, safety, EMC

information and operat in g conditions.

1. Do not overload wall outlets and extension cords as this can result

in a risk of fire or electric shock.

2. As no mains switch is fitted to this unit, en sure the local power

supply is switched OFF before connecting the supply cord.

3. The Receiver is not fitted with an on/off switch. Ensure that the

socket-outlet is instal le d near the equipment so th at it is easily

accessible. Failure to isolate the equipment properly may cause a

safety hazard.