43-1039.fm Page 8 Tuesday, August 17, 1999 10:12 AM

8.Align the bracket's keyhole slots with the wall plate studs and slide the base downward to secure it.

9.Press and lift out the handset holder. Rotate the holder 180 degrees as shown, and then snap it back into place so it holds the handset.

(Illus with callout: Lift)

10.Fully extend the base’s antenna and place it in a vertical position.

8

Mounting the Base Directly on a Wall

You need two wood screws (not sup- plied) for this mounting method.

1.Drill two holes 315/16 inches (100

mm)apart. Then thread a screw into each hole, letting the heads extend about 1/4 inch (6.5 mm) from the wall.

2.Plug one end of the supplied long modular cord into the phone jack on the back of the base.

3.On the bottom of the base, route the modular cord downward and under the left slot's clips. Then plug the cord's other end into a modular phone line jack.

Page 8
Image 8
Tandy ET-539 owner manual Mounting the Base Directly on a Wall