Tanita 4800 Attaching Control Panel Box to Scale, Leveling the Platform, Charging the Battery

Attaching Control Panel Box to Scale

1.Find the control panel box, transformer bracket, C-clamp and four (4) locknuts.

2.Attach the control panel box to the center handlebar rail using the C-clamp. Also mount the transformer bracket on two of the studs extending through the C-clamp. Secure the control panel box with the (4) locknuts.

3.Attach the cable lead to the 5-prong jack on the side of the control panel box. Secure by turning the knurled ring.

Control Box

Clamp 63935

Leveling the Platform

To level or adjust the height of the scale platform, carefully tilt the scale and turn the leveling feet either into or out of the platform underside.

NOTE: Adjust platform height so it does not touch floor or carpet. An incorrect weight reading will result if the ramp touches the floor or carpet.

BATTERY CHARGING

The rechargeable battery in this scale is similar to the no-maintenance lead-acid batteries used in automobiles. Since the battery is sealed, no checking of water level or adding of water to the battery is necessary. However, recharging at proper intervals and proper storage procedures are necessary, similar to an automobile battery. A fully charged battery will provide approximately 250 normal weighings before requiring recharging. When the display flashes “Lo-b,” the battery needs to be recharged.

Charging the Battery

A. Plug the battery charger power cord into the 3-prong jack on control panel box. Secure with clips.

B. Plug the battery charger into a 120 VAC outlet.

C. The battery will fully charge in 8 hours. THE SCALE MAY BE USED WHILE THE BATTERY IS CHARGING

NOTE: The specially designed charger built into this scale prevents the battery from being overcharged. Use of a charger or adapter other than the one designed for this scale can result in SERIOUS DAMAGE TO THE SCALE OR BATTERY.

Optimum battery life will be achieved if the scale is operated and stored connected to a 120 VAC. Always make sure that the scale is unplugged before moving.

STORAGE: When storing the scale for an extended period of time (and the unit is not connected to a

120 VAC), the battery should be fully charged. The battery should then be charged every three months. A discharged battery should be recharged as soon as possible to prevent its useful life from decreasing significantly. A discharged battery left in the scale can leak and cause permanent damage to the battery and scale. Store the unit in a cool, dry place.

PRODUCT DESCRIPTION

Control Panel Box

The 4800 control panel keypad has four membrane switches. The POUNDS, KILOS, and ZERO switches have both primary and secondary functions listed below. Only the primary functions are listed on the switch.

Pounds	Kilos	Keypad
		63911

WEIGHT

ZERO

www.tanita.com	Push “ON” button
		POUNDS
	and wait until zero
	appears before		KILOS
	stepping on scale
			ON
			OFF

3