GB
PROGRAMMING THE GUEST MODE
Guest mode allows you to programme the unit for a
Press 
button to activate the unit. Then follow the steps: Set Age, Select Female or Male, and Specify Height.
Note: If you step onto the platform before 0.0 appears the display will show Error and
you will not obtain a reading.
TAKING WEIGHT MEASUREMENT ONLY
Select Weight-Only Key
Press the
the display will flash for about 30 seconds, and then the power will automatically turn off. If you step off the platform, the weight will continue to show for about 5 seconds, then 0.0 will appear and the unit will shut off automatically.
TROUBLESHOOTING
If the following problems occur ...then...
A wrong weight format appears followed by kg, lb, or
Refer to Switching the Weight Mode on p.3.
Lo appears on the display, or all the data appears and immediately disappears.
Batteries are low. When this message appears, be sure to replace the batteries immediately, since weak batteries will affect the accuracy of your measurements. Change all the batteries at the same time with new
Error appears while measuring.
Please stand on the platform keeping movement to a minimum. |
|
The unit cannot accurately measure your weight if it detects movement. |
|
The Body Fat Percentage is more than 75%, readings cannot be obtained from the unit. |
|
The Body Fat Percentage reading does not appear or | appears after |
the weight is measured.
Your personal data has not been programmed. Follow the steps on p.3.
Make sure socks or stockings are removed, and the soles of your feet are clean and properly aligned with the guides on the measuring platform.
OL appears while measuring.
Reading cannot be obtained if the weight capacity is exceeded.
6
