OPERATING INSTRUCTIONS
Digital Lithium Scale –
1 | Measuring Platform |
2 | LCD Display |
Before Use
Select your preferred weight mode using the Weight Mode Switch.
Placing Scale
The scale should be used on a hard even surface for accurate weighing.
Not recommended for use on carpeted surfaces. Placing scale on a very soft, deep pile rug may affect weighing accuracy.
3 | Battery Compartment on Bottom of Scale |
4 | Weight Mode Switch on Bottom of Scale |
2
1
Instructions for Use
Gently tap the center of the scale with your foot. When “00.0” shows on the display, step on the scale (Fig. 1).
Stand still while the LCD flashes “00.0” for
3 seconds. The LCD will display your weight (Fig. 2). If you step off of the scale, your weight will be displayed for 5 seconds then the scale will automatically shut off. If you remain on the scale, the weight will be displayed for 10 seconds then automatically shut off.
FIG. 1 | FIG. 2 |
00.0
TAP HERE
3
Kg |
|
| Lb | lb |
|
|
| st/lb 4 |
kg
US/EURO UK/EURO
Specifications
Maximum Capacity: 330 lb (150 kg)
Graduation: 1/4 lb (0.1kg) (0.2 lb)
Power Supply: 1 x 3 volt CR2032 Replaceable Lithium Battery (Included)
UK Specifications
Maximum Capacity: 23 st 8 lb (150 kg) (330 lb)
Graduation: 1/4 lb (0.1 kg) (0.2 lb)
Power Supply: 1 x 3 volt CR2032 Replaceable Lithium Battery (Included)
Features
•Digital accuracy and reliability
•Durable construction,
•“L” message appears when battery needs replacing
Note: If you step on the scale without tapping the platform, the display will show “Err” for 2 seconds then automatically shut off.
Once the scale displays “00.0,” if you do not step on the scale in 10 seconds, the scale will automatically shut off.
“Err” will appear on the display when the scale’s weight capacity is exceeded.
Care and Maintenance
•Place the scale in an area free from heating equipment, high humidity, or extreme temperature changes.
•Never submerge the scale in water or spill chemical liquids on it. To clean, use a dampened cloth and mild detergent.
•Avoid excessive impact or vibration to the unit.
Replacing The Batteries
Lithium batteries can be typically used for many years before replacement is necessary. When the low battery sign, “L,” appears on the LCD, please replace with one new lithium battery.
Open the battery cover on the back of the measuring platform.
Insert the new battery as indicated.
Note: Be sure that the polarity of the batteries is set properly. If you do not intend to use this unit for a long period of time, it is advisable to remove the batteries before storage.
After Sales Service
Please contact the Tanita office nearest you regarding operation or trouble, request for repair, and/or placement of an order for parts for products.