1 − Introduction

Batteries

If batteries are used improperly, or if leakage or breakage occurs, the unit will not function.

Please observe the cautions indicated on the batteries and their packaging to ensure proper usage.

•Confirm + and – polarity and follow the indications when inserting new batteries into the remote control.

•Do not use old and new batteries together.

•Even if the battery is the same size, the voltage may differ. Do not use batteries of different specifications together.

•Do not attempt to recharge batteries that are non- rechargeable.

•Do not open or disassemble batteries, throw them into a fire or put them in water.

ªInserting batteries
1.Open the lid.
2.Confirm +/- polarity, and insert two AAA batteries.
3.Close the lid.
Connections

CAUTION

 

NOTE

Turn off the power of all the equipment before making connections.

Read instructions of each component you intend to use with this unit.

Be sure to insert each plug securely. To prevent hum and noise, do not bundle the connection cords with the power cord.

Connect ANALOG OUTs (L,R) jacks to the input jack of the amplifier with a RCA cable. Make sure to connect:

white plug ∑ white jack (L: left channel)red plug ∑ red jack (R: right channel)

Use an optical cable to output the signal from the DIGITAL OPTICAL OUT to the amplifier or recorder's input.

Use a RCA cable to output the signal from the DIGITAL COAXIAL OUT to the amplifier or recorder's input.

After all other connections are complete, connect the plug to the AC wall socket.

Before making a recording with a recorder connected to this unit's digital outputs, you need to standby this unit in playback mode.

Be sure to connect the power cord to an AC outlet which supplies the correct voltage. Hold the power plug when plugging or unplugging the power cord. Never pull or yank on the power cord.

The Digital output on the CD-160MkII does not include track increment data. Some recorders depend on this information to automatically update track numbers while dubbing. If you need this function, please connect the CD-160MkII and the recording device with the analog connections and use "level detection" mode on the recorder to detect track changes (please refer to the manual of the recorder for how to select this mode).

R L

ANALOG IN DIGITAL IN

DIGITAL IN

TASCAM CD-160MKll