Tascam VL-X5 owner manual Installation, Precautions, Connection, Connecting to the audio equipment

Installation

Installation

1 Precautions

Handling

Do not grab the speaker driver unit : the VL-X5 is packaged in box fitted tight, so your attention is required when taking speakers out of the box. To avoid the possible damage to the speaker units, hold both sides of the speaker to pull it out of the box. The units should not be touched to avoid damage even after it is out of the box.

Recommend to use high quality balanced or unbalanced cable for input connection.

Turn off the power of the VL-X5 and turn the Volume control of the VL-X5 to minimum before kaming the connection.

Connection

Connect XLR balanced or TRS balanced/unbalanced input of the VL-X5 to the output terminal of the audio equipment.

2 Connection

Assure that the power switch of VL-X5 is turned off and volume control of VL-X5 is turned to minimum. Connect male side of XLR balanced cable, TRS balanced cable, or TS unbalanced cable to the input connector of the VL- X5.

XLR / TRS Combo Jack

XLR

PIN 1: GND

PIN 2: HOT

PIN 3: COLD

TRS

Tip: HOT

Ring: COLD

Sleeve: GND

Power Cord	Power Cord
XLR Balanced Cable	TRS Balanced or Unbalanced Cable

3 Connecting to the audio equipment

Before connecting, make sure its power is turned off.

Plug the XLR balanced, TRS balanced or TS unbalanced cable to the corresponding output connectors of the audio equipment.

Pre-Amplifier, Sound card, Mixer Output

VL-X5 VL-X5

6 TASCAM VL-X5 Owner's Manual