Taurus Group Astral 16C manual Use and care, Do not move the appliance while in use

Use and care:

-Fully unroll the appliance’s power cable before each use.

-Do not use the appliance if the on/off switch does not work.

-Do not move the appliance while in use.

-Do not use the appliance if it is tipped up and do not turn it over.

-Disconnect the appliance from the mains when not in use and before undertaking any cleaning task.

-This appliance is for household use only, not professional or industrial use.

-This appliance is intended for adult use. Ensure that this product is not used by the disabled, children or people unused to its handling.

-This appliance should be stored out of reach of children and/or the disabled.

-Do not expose the appliance to extreme temperatures.

-Any misuse or failure to follow

the instructions for use renders the guarantee and the manufacturer’s liability null and void.

Installation

Assembly

-Fit the Adjustable Column (S) into the hole in the Support Base (B), place the counterweight (G) underneath the Support Base (B) and secure with the “L” shaped screw (I) inserting the washer (H) between the base and “L” shaped screw (I) (Fig.1)

-Fix the motor body (A) to the

adjustable column (S) through the support motor (F) and fix in place with the motor body screw fastening

(K)and the motor body fastening lever (L) making it coincide with the appropriate holes. Next introduce the incline adjustment screw (M) into the appropriate hole and tighten it with the inline adjustment lever (N)

-Unscrew the 4 screws and remove the washers situated further back from the front part of the motor body (A) Using these 4 screws screw in the rear grate (Q), leaving the carrying handle (E) on the upper part of the appliance.

Insert the helix (D) in the motor shaft (R) until the hole in the helix coincides with motor shaft groove. Next use the Helix tightening screw to tighten it completely.

Position the front grill (P) on to the back grill (Q), press them together ensuring that an accurate fitting between the two grills and alignment with the clips on the front grill. Make sure that the hole in the front grill coincides with the security screw (O).

To ensure that the front and rear grills are securely fitted together secure each one with the security screw (O). This should be introduced through the hole so that the grills cannot be separated without the help of a tool.