How to Set up Your WeatherGuide System | |||
|
| ™ |
|
Your WeatherGuide™ bas unit is powered b 2 AAA batteries (not | |||
included). |
|
|
|
Remov | the batte y compartment cover on the back of the unit. | ||
Install 2 AAA batteries. Replace the battery co partment cover. | |||
Important:Power the base unit befor installing batteries in the re- | |||
m te sensor,or the units’ ransmissions ma not properlyconnect. | |||
Remote S nsors |
|
| |
Unscrew th | 4 screws securing the remote sensor’s battery compart- | ||
ment c ver located on the b ck of the unit. Install 2 AAA batteries. (Tip: Lithium batteries are r commende in extremely cold or hot lo- cations.)
First,power up the base unit,using 32 AAA batteries. Next,install 2 AAA batteries into the remote sensor.Place the base unit as close as possi- ble to the remote unit.
There is a Channel switch in the remote sensor battery compartment. Move the switch to Channel 1.
Press the “TX” button located inside the remote sensor battery compartment.This will send a transmission signal to the base unit. The red LED Indicator light will flash when a signal is transmitted.
