Taylor 300 Closing Procedure, Draining Product From the Freezing Cylinder, Rinsing

22 Models 336, 338 & 339Operating Procedures
Step 5
Press the “AUTO” button. The “AUTO” light willcome
on indicating the main refrigeration system is
operating. When the unit cycles off, the product will be
at serving viscosity.
Figure 37
Note: The mix refrigeration light will come on,
indicating the mix refrigeration system is operating to
maintain the mix in the mix hopper.
Step 6
Fill the hopper with mix. As the mix level comes in
contact with the mix level sensing probe on the rear
wall of the hopper, the “MIX LOW” light will shut off.
Step 7
Place the mix hopper cover in position over the mix
hopper.
Repeat Steps 1 through 7 for the other side of the
freezer.
Closing Procedure
To disassemble your unit, the following items will be
needed:
STwo cleaning pails
SSanitized stainless steel rerun can with lid
SNecessary brushes (provided with freezer)
SCleaner
SSingle service towels
Draining Product From the
Freezing Cylinder
Step 1
Press the “AUTO” button, cancelling compressor and
beater motor operation.
Press the mix refrigeration button, cancelling the mix
hopper refrigeration system.
Step 2
Remove the hopper cover, hopper gasket and air tube.
Taket hese parts to the sink for cleaning.
Step 3
If local health codes permi tth e use of rerun,place
a sanitized, NSF approved stainless steel rerun
container beneath the door spout. Press the WASH
key and lower the draw handle. Drain the remaining
product from the freezing cylinder and mix hopper.
When the flow of product stops, press the WASH key
and raise the draw handle. Place the sanitized lid on
the rerun container and place it in the walk--in cooler.
Note: Iflocal health codes DO NOTpermit the use
of rerun,the product must be discarded. Drain the
product into a mix pail and properly discard it.
Repeat Steps 1 through 3 for the other side of the
freezer.
Note: For the Model 336, both sides must be in
WASH. If one side is in AUTO and the other is in
WASH,the side t hat is in WASH will continue to freeze.
ALWAYSFOLLOW LOCAL HEALTH CODES.
Rinsing
Step 1
Pourt wo gallons (7.6 liters) of cool clean water int o the
mix hopper. With the brushes provided, scrubthe mix
hopper, mix inlet hole and mix level sensing probe.
Step 2
With a pail beneath the door spout, raise the prime plug
and press the “WASH” button.
Step 3
When a steady stream of rinse water is flowing from
the prime plug opening in the bottom of the f reezer
door, lower the draw handle. Drain all the rinse water
from the freezing cylinder, raise the draw handle and
press the “WASH” button, cancelling t he “WASH”
mode.
Repeat Steps 1 through 3 for the other side of the
freezer.