3Models 380/381 Safety

050906
Section 3 Safety
Weat TaylorCompany are concerned about the safety ofthe
operator when he orshe comes in contact with the freezer
andits parts. Taylorhas gone to extremeeffortsto design and
manufacturebuilt-in safety features to protectboth you and
the servicetechnician. As an example, warning labelshave
been attached to the freezer to further point out safety
precautionsto the operator.
IMPORTANT --Failure to adhere to the following
safetyprecautions may result in severe personal injury.
Failureto comply with these warnings may damage the
machine and its components.Component damage will
result in part replacement expense and service repair
expense.

To OperateSafely:

DO NOT operate the freezerwithout reading this
operator’smanual.Failure to follow thisinstruction mayresult
in equipment damage, poor freezer performance, health
hazards, or personalinjury.
SDO NOT operate thefreezer unless it is properly
grounded.
SDO NOT attemptany repairs unless the main
power supply to the freezerhas been
disconnected.
SDO NOT operate thefreezer with larger fuses
than specifiedon the freezer data label.
Failureto followthese instructions may result in electrocution
or damage to the machine. Contact your local authorized
TaylorDistributor for service.
DONOT use a water jet to clean or rinse the freezer.
Failure to follow this instruction may result in serious
electricalshock.
SDO NOT allow untrainedpersonnel to operate
this machine.
SDO NOT operate thefreezer unless all service
panels and access doors arerestrained with
screws.
SDO NOT remove the door,beater, scraper blades,
or driveshaft unless the power switch is in the
“OFF”position.
SDO NOT put objects or fingersin the door spout.
Failure to follow these instructions may result in
contaminatedproduct or severe personal injury tofingers or
hands fromhazardous moving parts.
USE EXTREME CAUTION when removing the
beater assembly. The scraperblades are very sharp and
may cause injury.
These freezersmust be placed on a level surface.
Failureto comply may result in personal injuryor equipment
damage.
DO NOT obstruct air intake and discharge openings: 6”
(152 mm) minimumair space on front, sides and rear of the
unit.Failure to follow thisinstruction may cause poor freezer
performanceand damage to the machine.
These freezers are designed to operate indoors, under
normalambient temperatures of 70_-- 7 5 _F(21_-- 2 4 _C).The
freezers have successfully performed in high ambient
temperaturesof 104_F(40_C)at reduced capacities.
NOISELEVEL: Airborne noise emissiondoes not exceed 78
dB(A) when measured at a distanceof 1.0 meter from the
surfaceof the machine and at a height of 1.6 metersfrom the
floor.