
9
Model 390 Operating Procedures
Closing ProceduresTodisassemble the model 390, t he following items will
be needed:
STwo cleaning pails
SSanitized stainless steel rerun can with lid
SNecessary brushes (provided with freezer)
SCleaner
SSingle service towels
Draining Product From TheFreezing CylinderStep 1
Place the control switch in the “OFF” position as far
ahead of cleaning time as possible. This will allow
frozen product to soften for easier cleaning.
Step 2
Removet he hopper cover, gasket, and feed tube. Take
these parts to the sink for cleaning.
Step 3
With a sanitized pail under the door spout, place the
control switch in the “WASH” position and move the
draw handle to the right. When all the product stops
flowing from the door spout, move the draw handle to
the left and place the control switch in t he “OFF”
position. If local health codes permit the use of rerun,
empty the rerun into its can. Cover the c ontainer and
place it in the walk-in cooler.
ALWAYSFOLLOW LOCAL HEALTH CODES.
RinsingStep 1
Pour two gallons (7.6 liters) of cool, clean water into
the mix hopper. With the brushes provided, scrubt he
mix hopper, mix inlet hole and mix level sensing
probes.
Step 2
With a mix pail beneath the door spout, place the
control switch in the “WASH” position and move the
draw handle to the right. Drain all the rinse water fr om
the freezing cylinder. When the rinse water stops
flowing from the door spout, move the draw handle to
the left and place the control switch in t he “OFF”
position.
Repeat this procedure until the rinse water being
drawn from the freezing cylinder is clear.