Remote Sensor, Standby, Numeric buttons, Sleep

APOWER

Press this switch to turn the unit standby or off.

The equipment draws nominal non-operating power from the AC outlet with its POWER switch in the OFF position.

BSTANDBY/ON

When the POWER switch of the main unit is depressed, use this button to turn the unit on or standby.

The standby indicator lights when the unit is in the standby mode. When the unit is turned on, it goes off.

CCD DIRECT

Use this button to turn on or off the CD direct function. When the CD direct function is on, the sound input from the CD jack bypasses the BASS, TREBLE and BALANCE control.

The indicator lights when the CD direct function is on.

DVOLUME

Turn this knob (or press the VOLUME buttons of the remote control unit) to adjust the volume.

EINPUT SELECTOR

Use this knob (or buttons of the remote control unit) to select a source.

FREC SELECTOR

Use this knob to select a source to be recorded. Select “OFF” when it isn’t in use.

GBALANCE

Use this knob to adjust the balance of the speakers. Normally, set the knob to the center position.

HRemote Sensor

When operating the remote control unit, point it towards the remote sensor.

ITREBLE

Use this knob to adjust the level of high frequency sound range.

JBASS

Use this knob to adjust the level of low frequency sound range.

KPHONES

For private listening, insert the headphones plug into this jack, and adjust the volume by turning the VOLUME knob.

aSTANDBY

When the POWER switch of the main unit is depressed, use this button to turn the unit standby.

bON

When the POWER switch of the main unit is depressed, use this button to turn the unit on.

cButtons for the operation of TEAC R-H300mkII(TAPE).

dButtons for the operation of TEAC T-H300DABmkIIIor T-H300mkIII(TUNER).

<Following buttons work on the T-H300DABmkIIIonly. They don’t work on T-H300mkIII:

FUNCTION/FM MODE, AUTO TUNE, ENTER, INFO

eButtons for the operation of TEAC PD-H300mkIII(CD).

fFL DIMMER

When the T-H300DABmkIII/T-H300mkIIIis connected by a remote control cord, use this button to dim the display of T-

H300DABmkIII/T-H300mkIIIand PD-H300mkIII.

<The T-H300DABmkIII/T-H300mkIIIis indispensable for this function.

gNumeric buttons

Use these buttons to select a track number or a preset channel.

Press the CD or TUNER button to select the component to be operated, and then press the numeric buttons.

(Even when the CD or TUNER button is pressed without pointing at the main unit, the selection of the remote control unit will be changed.)

For instance, to select track number 35, first press the CD button, and then press “3” and “5”.

To select numbers less than 10, press “0” and then the number. As an example, to select number 5, press “0” and “5”. (Optionally, you may press just the number “5” and then wait a few seconds.)

hSLEEP

Use this button to set sleep timer.