Remote Control Unit

Using the provided remote control unit, you can also operate the unit.

When operating the remote control unit, point it toward the remote sensor on the front panel of the unit.

<Even if the remote control unit is operated within the effective range, it may not work if there are any obstacles between the unit and the remote control.

<If the remote control unit is operated near other appliances which generate infrared rays, or if other remote control devices using infrared rays are used near the unit, it may operate incorrectly. Conversely, the other appliances may operate incorrectly.

Battery Installation

1Remove the battery compartment cover.

2Insert two “AA” (R6, SUM-3) dry batteries. Make sure that the batteries are inserted with their positive “+” and negative “_” poles positioned correctly.

3Close the cover.

Battery Replacement

If the distance required between the remote control unit and main unit decreases, the batteries are exhausted. In this case replace the batteries with new ones.

For more information about collection of batteries, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items.

Precautions concerning batteries

<Be sure to insert the batteries with correct positive “+” and negative “_” polarities.

<Use batteries of the same type. Never use different types of batteries together.

<Rechargeable and non-rechargeable batteries can be used. Refer to the precautions on their labels.

<When the remote control unit is not to be used for a long time (more than a month), remove the batteries from the remote control unit to prevent them from leaking.

<If the batteries leak, wipe away the liquid inside the battery compartment and replace the batteries with new ones.

<Do not use any other batteries not specified. Do not mix new batteries with old ones or use different types of batteries together.

<Do not heat or disassemble batteries and never throw them in the fire or water.

<Do not carry or store batteries with other metallic objects. The battery may short circuit, leak or explode.

<Never recharge a battery.

Turntable Cover

To attach the turntable cover

1.Slide the hinges into the hinge sockets on the rear of the turntable.

2.Align the hinge sockets on the turntable cover with the top of the hinges, and slide the cover down into place.

ENGLISH

To detach the turntable cover

Hold the cover on both sides and gently pull upward to remove it from the hinges.

How to open/close the turntable cover

To Open

Lift the turntable cover halfway until it stops.

<The cover will now stay open.

To Close

Slowly lower the cover until it touches the turntable base.

Note:

Make sure you grasp the cover by the front edge to avoid removing hinges.

Be careful not to pinch your fingers when the cover closes.

9