Recommendations and Precautions

1.Operation

Please read the following instructions carefully and follow them closely, they concern your personal safety and can affect the operation of your equipment.

 

Television sets require ventilation to avoid overheating which can

GB

 

damage components. Make sure that the rear ventilation openings are

 

 

not covered up by curtains, cloths, newspapers, etc. There must be

 

 

enough room inside built–in units to allow cooling air to circulate freely.

 

 

Do not install the set next to heating.

 

 

The appliance is designed to operate in a dry room. Should you, for any

 

 

special reason, wish to use it outdoors (e.g. balcony, veranda, tent,

 

 

etc.), always make sure it is properly protected against any form of

 

DO NOT OBSTRUCT VENTILATION OPE-

moisture (dew, rain, splashing).

 

 

 

NINGS.

Before turning on a cold set in a warm room, wait until any

 

 

condensation on the screen has evaporated. Never open up the rear

 

 

panel of the television set. Have your aerial installed by an authorised

 

 

dealer or specialist.

 

 

At the end of the evening TV programme or in the event of prolonged

 

 

absence, you should switch off your set using the ON/OFF button.

 

 

Even if the ON/OFF switch is in the OFF position, the set is not

 

 

completely disconnected from the mains. To disconnect the set

 

 

completely, pull out the mains plug.

 

AVOID WATER,

Remove the mains plug from the wall outlet in the following cases:

 

HEAT,

1. During thunderstorms. It is wise to disconnect the aerial plug too in

 

DIRECT SUNLIGHT.

this case.

 

 

2. If you notice any odour or smoke coming from your set.

 

 

Additional information:

 

 

Your TV set is adequately shielded to prevent X–ray emission.

 

 

Acceleration voltage does not exceed the maximum value of 26 kV.

 

 

Work by unqualified technicians, modification of the high–voltage

 

 

setting or replacement of the tube with a model that does not comply

 

Do not place audio loudspeakers next to

with the manufacturer’s specifications can lead to a considerable

 

increase in X–ray emission.

 

your TV set as the magnets in the spea-

 

A set changed in any of the above ways no longer complies with the

 

kers may cause coloured patches on the

 

manufacturer’s specifications and should not be put back into service.

 

screen.

 

 

2. Cleaning

The screen should be cleaned using liquid window cleaner.

·Never use abrasive cleaners.

·Clean the front and cabinet using a soft cloth dipped in mild detergent. The use of solvents such as white spirit or alcohol–based products may damage your set.

·Make sure to clean the vents at the rear of your set regularly.

3. Demagnetisation

The earth’s magnetic field may affect your television set, causing coloured patches to appear on the screen. If this happens:

·Switch off the set using the ON/OFF button.

·Wait about an hour and then switch on again using the ON/OFF button.

This operation demagnetises the screen automatically. If coloured patches are still visible, repeat the procedure.

1