Technicolor - Thomson DPL560HT Fine Setting of the Components, Stereo, Digital Input, N O T E

DPL560-EN 4/11/02 5:28 PM Page 24

Advanced Sound Control

Stereo Input Signal Setting

The Stereo mode uses the two main channel outputs from the front speakers. Use this mode if you have connected the front speakers only.

DSP (Digital Sound Processor)

These digital sound effects resemble sounds in a real environment such as

(STADIUM/CONCERT/THEATRE/ARENA/CHURCH/CLUB/). DSP automatically converts analog audio signals to digital ones which enables you to adjust the sound without degrading the sound quality. Different modes will give you different feel of size and type of listening environment. (Not available in Dolby Digital (DVD))

The receiver defaults to the most convenient settings for your easiest use (see table).

If your connection is different from the default set- ting,

1.Select the source

2.Press DIGITAL INPUT button to toggle among opti- cal/ coaxial/ analog to match your connection. Your selection will be stored automatically.

The selected source and input source will be displayed on the display as long as they are active, except for some temporary change of display (e.g. adjusting vol- ume).

Fine Setting of the Components

The receiver has pre-selected surround mode once you turn on the unit by pressing the Source Buttons (like DVD, SAT, CD) directly. The default surround modes for different components are listed in the table below.

If you decide to change the surround mode, you can press the SURR MODE repeatedly to toggle among the different surround mode choices and select the one you want.

Pro Logic		Stereo
Source/	If Digital Input (optical		If Analog Input
Input	or coaxial) is selected		is selected
DVD	Dolby Digital/PRO LOGIC		PRO LOGIC
SAT	Dolby Digital/PRO LOGIC		PRO LOGIC
VCR	N/A		PRO LOGIC
V-AUX	N/A		PRO LOGIC
TV	Dolby Digital/PRO LOGIC		PRO LOGIC
CD	STEREO		STEREO
TAPE	N/A		STEREO
TUNER	N/A		STEREO

The receiver will keep the last selection in memory.

Digital Input

Select this setting to play digital signals from a DVD, CD, LD player, SAT or TV.

SOURCE	DEFAULT INPUT (as seen on display)
SAT	Analog (SAT/ ANL)
DVD	Analog (DVD/ ANL)
CD	Analog (CD/ ANL)
VCR	Analog (VCR/ ANL)
V-AUX	Analog (VAUX/ ANL)
FM/AM	Built-in Tuner
TAPE	Analog (TAPE/ ANL)
TV	Analog (TV / ANL)

N O T E

Digital input is only available for DVD, SAT, CD and TV

Analog Input

Select this setting to play analog signals from a cas- sette deck, VCR or turntable.

SOURCE	AVAILABLE INPUT
SAT	ANL/Optical/Coaxial
DVD	ANL/Optical/Coaxial
CD	ANL/Optical/Coaxial
VCR	ANL/ - / -
V-AUX	ANL/ - / -
TAPE	ANL/ - / -
TV	ANL/ Optical / -

20