64 EN
T
PO
USC
HOP
"Y
SNT
AO
PST
HA
OP
TE
"
POWER Switch
Rewind Button (
2
)
Fast-Forward Button (
3
)

Dubbing Images Stored In A

MultiMediaCard To A Tape

Images can be dubbed from a MultiMediaCard to a tape.
1
Load a MultiMediaCard ( pg. 12) and cassette
( pg. 10).
2
Set the POWER Switch to “ ” while pressing
down the Lock Button located on the switch. Open
the LCD monitor fully or pull out the viewfinder fully.
3
2To locate the point where you wish to dub a still
image, play back the tape. Stop playback at the
desired point.
4
3Set the POWER Switch to “
MEMORY
PLAY
” while pressing
down the Lock Button located on the switch. To
select a still image to be dubbed, perform Index
Playback ( pg. 47), Auto Playback ( pg. 45) or
press
2
or
3
to select the image you wish.
5
To engage Dub-Standby, press SNAPSHOT. The
message “TO COPY TO TAPE PUSH "SNAPSHOT"”
appears.
6
While the message is being displayed, press
SNAPSHOT again. The selected still image is
recorded on the tape for approx. 6 seconds.
•The indicator disappears when dubbing is
complete.
NOTES:

If SNAPSHOT is pressed in step 5 when the tape’s erase

protection tab is set to “SAVE”, the message “COPYING

FAILED” is displayed.

The XGA image is dubbed onto the tape at 720 x 480

pixels.

You can superimpose a snap frame over the selected still

image to be dubbed (

pg. 51) and dub it to a tape.

After step 4, superimpose a snap frame over the still

image and go to step 5.

Display
DUBBING

(cont.)

SNAPSHOT Button
Lock Button
VMD22 EN(34/65) 29/08/00, 15:1664