EN85

INDEX
Docking Station
1PC Connector [DIGITAL STILL]............ pg. 58
2J Terminal/Edit Connector
[JLIP (Joint Level Interface Protocol)
(EDIT)] ................................................ pg. 71
•Connect to a JLIP-compatible camcorder or
VCR to control it from the computer using the
provided Software.
NOTE:
Make sure that the camcorder is turned on while
connecting the camcorder to a PC using the
Docking Station’s JLIP connector. If the camcorder
is turned off (because the POWER Switch is set to
“OFF” or due to Auto Shut Off* etc.) while the
JLIP programme software is used, it will be
impossible to control the connected devices from
the computer. In such a case, first try turning the
camcorder on again, or unplug the JLIP connec-
tion cable from the Docking Station’s JLIP
connector. Then, initialise or run the software
again.
*Auto Shut Off:
If 5 minutes elapse in the Record-Standby mode
or in the Pause mode, the camcorder’s power
shuts off automatically to conserve energy.
•Connect the editing cable when performing
Random Assemble Editing......... pg. 70 – 75

5

6

7

1

4

!

2

8

9

0

3Not applicable
4External Stereo Microphone Input
Connector [MIC] ................................. pg. 76
5Stud .................................................... pg. 56
6Screw.................................................. pg. 56
7Multi Connector
The Docking Station can be connected with this
camcorder through this connector. Never touch it
with your hand or hit it with a hard object; if the
pins are damaged, the connectors will become
unusable due to contact failure.
8S-Video Input/Output Connector
[S]................................................. pg. 56, 71
9Video Input/Output Connector
[VIDEO]........................................ pg. 56, 71
0Audio Input/Output Connectors
[AUDIO L/R]................................. pg. 56, 71
!Screw Knob......................................... pg. 56
To attach the camcorder, tighten this clockwise.
VMD22 EN(66/100) 29/08/00, 15:4785