Getting Started - Initial Set Up

GETTING STARTED  INITIAL SET UP

1)Using the RF cable supplied, connect the TV to the TV Aerial wall socket (Fig A)

2)Connect the power cable to the Electrical outlet (Fig B)

Fig B

Fig A

3)Switch on the television using the power on/off switch.

4)Insert the batteries supplied into the Remote control and press the Standby button to power on the TV

Power on/off

5)You will now be welcomed with the initial set-up screen.

If it does not appear, on the remote control, please press [MENU] then 8-8-8-8 and the menu will appear.

Press OK on the remote control and tuning will start.

6)After tuning the following screen will appear.

If you are missing channels, the reason for this is likely to be signal strength, you should consider connecting signal booster and re-tuning the TV.

Tip: If the TV finds some, but not all, of the Digital channels, the TV is functioning correctly but the signal being received is not strong enough. (The signal strength needs to be above 85% - you can see the signal strength the TV is receiving when you change channels/ programmes) you will need to increase the signal reception in order to receive all of the channels available. The most economical way to do this is by purchasing and connecting a ‘signal booster’ in between the TV and the TV aerial socket. If this does not solve the problem, you will need to upgrade the TV aerial to a digital hi-gain compatible aerial

11

Manual - Technika - LCD32-270(CR).indd Sec1:11

10/12/2010 3:48:16 PM

Page 10
Image 10
Technika LCD 32-270 manual Getting Started  Initial SET UP