PLAYING A CD

You can load and play music CDs and navigate a CD using the buttons on the remote control or the front panel.

Selecting CD operation:

•Move the FUNCTION slide switch to select ‘CD’.

Loading a CD:

•Open the CD compartment by pressing down on the OPEN/CLOSE area at the front corner of the CD lid.

•Holding the disc by the edges, place the disc on the turntable in the centre of the CD loading bay with the label uppermost.

•Gently close the CD door.

The unit will read the disc and display the total number of tracks on the disc.
Removing a CD:

•Make sure that the disc is stopped.

•Open the CD compartment by pressing down on the OPEN/CLOSE area marked at the front corner of the CD lid.

•Holding the disc by the edges, lift the disc off the turntable and place it back in the case.

•Gently close the CD door.

Playing a CD:

•Press the //,button.

The play symbol will appear on the display and the track number playing will be shown.

Pausing a CD:

•Press the //,button while the CD is playing. The display will flash.

Stopping CD play:

•Press the . button (or the STOP button on the remote

control) while the CD is playing. The CD will stop.

Selecting tracks:

•Press the ]/} or {/[ button to select the next or previous track.

NOTE:- When pressing {/[ while playing a track, the first press will replay the current track.

Fast search:

•Press and hold the ]/}or {/[ button to fast search forward or backward through a track.

The track will search at high speed.
Repeat play:

•Press the REPEAT button to cycle through the available repeat modes - ‘Repeat 1’, ‘Repeat all’ or ‘Repeat off’.

If a repeat mode is set, the mode selected will be shown on the display.

Selecting‘Repeat 1’will continuously repeat the current track. Selecting ‘Repeat all’ will repeat the entire disc continuously.

Random play:

Random play will play the tracks on the disc in a random order.

•Press the RANDOM button to turn Random play on or off.

RANDOM will be shown on the display.

NOTE:- Random play can be set at the same time as ‘Repeat All’ to repeat the contents of the disc in a random order.

PROGRAM PLAY

You can load a disc and store a programmed selection of up to 20 tracks to play from the disc in your preferred sequence.

To set a program:

•Load a disc and wait for it to read.

•Press the PROGRAM button (or PROG on the remote control).

The display will show 01 briefly (the position of this track in the program), then flash 00 PROG.

•Select the track number you want to program by pressing the ]/}or {/[button.

•To save this track into the program sequence, press the PROGRAM button.

The display will show 02 briefly, then flash 00 PROG.

•Repeat these two steps until you have stored all the tracks in the program sequence.

Playing the program:

•Press the /,button to start the program playing.

The program will begin to play and PROG will show on the display to show that a program is being played.

Selecting tracks:

•You can navigate through the tracks stored in the program by pressing the ]/}or {/[button.

8