PRELIMINARIES
UNPACKING
The carton contains:
! The |
LOUDSPEAKER CONNECTION
Plug each loudspeaker into the loudspeaker connectors of the main unit as shown in the diagram below. Plug the connectors in firmly but do not use excessive force.
SETTING THE TIME
!Switch the function selector to ‘CD’. The clock must be set when the selector is in this position.
The power light comes on and the
display lights up.AM
! One pair of loudspeakers: |
Example: set the time to 3:40 pm.
FM
PM
Unpack and inspect the components carefully. If any item is damaged or missing, contact the Tesco store from where you purchased this product, or if that is not possible, your nearest Tesco store. Please have your receipt ready when you call.
Retain the packaging. If you dispose of it, do so in accordance with recycling regulations in your area.
Retain the User Handbook. If you pass the unit on to a third party make sure you pass on the handbook.
PREPARATION
Remove any strips of tape holding the CD door.
Press the DOOR OPEN button to open the CD lid. Carefully remove the protective card from the CD mechanism. Close the CD door and discard the card and the pieces of tape.
SITING AND PLACEMENT
Make sure there is a suitable power point within easy reach.
The means of disconnection of the appliance is the mains plug. This must not be obstructed and must be freely operable at all times.
Site the system on a stable surface (ideally a stout shelf) where it is unlikely to fall or get knocked over. The speakers which should be placed on either side of the main unit with at least150mm between each speaker and the main unit.
RIGHT SPEAKER SPEAKERS LEFT SPEAKER | |
R | L |
When running speaker cables, keep them away from areas whey they could cause danger.
You will get better stereo if the speakers are placed some distance from each other.
CONNECTING THE MAINS
Check that the mains voltage on the rating plate is the same as the voltage in your area.
! Switch the Power Switch on the rear panel to the “0" - OFF position.
!Switch the FUNCTION SELECTOR to OFF.
!Uncoil the AC power cord, plug the cord into the wall socket and switch on the mains power.
!Switch the Power Switch to the “I” ON position. The system will now go to Standby. In Standby the display will light up very faintly and the clock time is just visible but no controls are operable.
!You may now set the clock time if you wish but this is optional. No control functions are affected if you choose not to set the time.
The Time Setting buttons are on the rear panel.
! Press and hold the TIME SET |
| |
TIME SET | ||
button. | ||
| ||
! Hold down the Time Set button | HOUR | |
and press the HOUR button to set | MINUTE | |
the hours. When the time goes | ||
| ||
past 12:00, the display moves |
| |
| ||
from AM to PM. |
| |
! Hold down the Time Set button | I3:40 | |
and press the MINUTE button to PMFMAM |
set the minutes.
!Release the Time set button.
Standby and Power Off
When power is connected and the rear panel power switch is on, switching the Function Selector on the front panel to “off” sets the unit into standby. In Standby the unit power consumption is below 1 Watt and the front panel is powered at a very low level, with no backlight.
The only point of leaving the unit in standby is to power the clock. As there are no other settings you can switch the unit off at the rear panel if you wish but you will have to reset the clock (if required) when you switch on again.
If you are not using the unit for some time always set the rear panel switch to OFF for safety.
4