Technika T50DM Set heat selector knob to select Strong, dry or Soft dry level, Dry time settings

Using Method

4.	Set ' heat selector knob' to select ' Strong
	dry' or ' Soft dry' level.
	' Strong dry' level for large quantity and low room temperature.	Soft
	' Soft dry' for non heat-resistant clothes.	Strong
5.	Dry time settings	Heat selector knob

Select dry program according to clothes materials and quantity, turn the timer knob to relative position. The dryer starts running.

Please refer to page 10 ' Control panel and its functions' and page 12 ' Dry Capacity Dry Time Reference Table' .

Caution: Dry timing knob cursor	Do not
shouldn't be set at the blank area,
	point the
as indicated in the right figure.	cursor to
	blank

Do not point the cursor to blank.

Air dry	60	OFF	Cool
		0
40			20

40

20

60

0

OFF

80

220

	100
200
Hot	120
180	140 Warm
160

Drying time(min)

6. Do not take the laundry out until drying process is done

The last 20 minutes of hot air drying is cooling to reduce the temperature of laundry inside the drum.

To take the laundry out during drying, please run cooling operation first since the temperature inside the drum must be high.

Static electricity, due to friction, will be generated on clothes made of chemical fibre after dried. You can feel it when taking them out, which is normal and shall not to be worried about.

7. Unplug the power cord

Please hold plug to unplug power cord from

a receptacle. Do not pull electrical wire directly to prevent internal breakage or bad connection.

8. Clean filters

Clean the lint filter after every load and before each use. A clean filter ensures sufficient drying. A layer of lint on the filter reduces airflow through the clothes and prolongs drying time

Refer to the instructions on page 13.