Users safety summary
Terms in | CAUTION | Conditions that can result in damage to the product. |
manual: | WARNING | Conditions that can result in personal injury |
|
| or loss of life. |
Power source: For 110 VAC printers, Do not apply more than 140 volts RMS between the supply conductors or between either supply conductor and ground. Use only the specified power cord and connector. For 220 VAC printers, do not apply more than 260 volts RMS between the supply conductors or between either supply conductor and ground. Use only the specified power cord and connector. Refer to a qualified service technician for changes to the cord or connector.
Operation of product: Avoid electric shock by contacting a qualified service technician to replace fuses inside the product. Do not operate without the covers and panels properly installed. Do not operate in an atmosphere of explosive gases.
Safety instructions: Read all installation instructions carefully before you plug the product into a power source.
Terms on | CAUTION | A personal injury hazard exists that may not be |
product: | apparent. For example, a panel may cover the hazardous area. | |
| Also applies to a hazard to property including the product itself. | |
| DANGER | A personal injury hazard exists in the area where |
|
| you see the sign. |
Care of product: Disconnect the power plug by pulling the plug, not the cord. Disconnect the power plug if the power cord or plug is frayed or otherwise damaged, if you spill anything into the case, if product is exposed to any excess moisture, if product is dropped or damaged, if you suspect that the product needs servicing or repair, and whenever you clean the product.
Ground the product: Plug the