MODE Menu
Impedance
STOP
The Slope, Level and Impedance items are used to set the trigger conditions for the external trigger signal.
Figure 3
External Trigger Signal
Output Signal
Figure 3 162: Output Waveform for External Trigger Signal in Triggered Mode
Gated Mode Use Gated mode to control waveform or sequence output with a gate signal. The gate signal depends on the gate source. It can be generated from the external gate signal applied to the TRIGGER INPUT connector or while the front panel MANUAL button is pressed.
While the front panel MANUAL button is pressed, the specified waveform or sequence is output. When you let the MANUAL button go, the waveform output stops. When you press the MANUAL button again, the waveform or sequence output resumes from the level where it left off. While you are pressing the MANUAL button, if you press any other button, the instrument goes back to the mode before the MANUAL button was pressed.
The specified waveform or sequence waveform is output while a valid external gate signal is being received through the TRIGGER INPUT connector. After output stops, at the next external gate signal, the waveform or sequence resumes from the waveform level where it left off.
When Gated is selected, the following items will be displayed in the side menu:
Polarity
Level
3 234 | AWG2021 User Manual |