MODE Menu

Impedance

STOP

The Polarity, Level and Impedance items are used to set the gate conditions for the external gate signal.

Figure 3 -163 shows the output waveform for an external gate signal.

External Gate Signal

Output Signal

Figure 3 !163: Output Waveform for External Gate Signal in Gated Mode

Burst Mode Use Burst mode to output the specified waveform or sequence for the burst count when a trigger is generated, then stop output. The trigger signal depends on the trigger source. It can be generated from the external trigger signal applied to the TRIGGER INPUT connector or by pressing the front panel MANUAL button.

During waveform output, if the MANUAL button is pressed or another external trigger signal is generated, this trigger has no effect.

When Burst is selected, the following items will be displayed in the side menu:

Polarity

Level

Impedance

Burst Count

STOP

The Slope, Level and Impedance items are used to set the trigger conditions for the external trigger signal.

Figure 3 -164 shows the output waveform for an external trigger signal.

AWG2021 User Manual

3 !235