Operating Examples

Figure 2 ￿52: MODE Menu

2.Select Cont from the bottom menu.

This operation mode continuously outputs the set waveform. Also, ªRun- ningº is displayed in the trigger status area on the upper right section of the screen to show that the set waveform is being output.

3.Press the front panel CH1 On/Off button to enable waveform output.

When the output is on, the On/Off indicator lights up. This operation outputs the specified waveform from the CH1 output connector. Set the oscilloscope appropriately to display the waveform on the oscilloscope screen.

You can use the marker output from the instrument as the external trigger for the oscilloscope. The marker signal is set in high state at data point 0. See Figure 2 -53. The marker signal can be set to any point using the waveform edit function.

AWG2021 User Manual

2 ￿63