CL2900 SERIES TELEPHONE DIAGRAM
INCLUDED IN YOUR PACKAGE
Cordless Handset NiMH Battery
Rubber Battery Screw Cover Phillips Screw
Base Unit
AC Adapter
10 foot, 4 Wire RJ- 11 Line Cord
Line 1
Line 2
Redial/Flash Channel
Message Waiting Lamp
Charge LED | Modular Phone |
| Line Jack |
| Data Port |
| Store Key |
Hold | Flash Key |
Programming Port | |
Conference | Auto Dial Keys |
| |
| |
| |
Handset | DTMF Keys |
| |
Volume | Handset |
Keys | |
| Volume Keys |
| Redial |
| Mute |
| Page |
Hold Button | Speakerphone |
Line1 | Line2 |
| Conference |
CONTACTING TELEDEX
Telephone: | (408) |
Mail: | 6311 San Ignacio Avenue |
| San Jose, CA USA 95119 |
Internet: | www.teledex.com |
email: | sales@teledex.com |
Part Number
Copyright © 2001 Teledex LLC. All rights reserved.
15 foot, 8 Wire RJ- 45 Cable Clear Plastic Overlay
User Guide
PREPARING TO USE THE CL2900 SERIES TELEPHONE
1.Prepart to install the battery into the cordless handset by firmly pressing down on the top of the battery cover and sliding it off.
2.Locate the lightly embossed numbers “1” and “2” on the battery’s plastic connector.
3.Insert the battery connector into the Handset’s connector with the embossed numbers facing up.
Note: The handset may “beep” when the battery is connected. This is not an indica- tion that the telephone is ready to use. To obtain optimal performance of the tele- phone, be sure to charge the battery for 15 to 20 hours.
4.Replace the battery compartment cover and retaining screw.
5.Insert the provided rubber screw cover.
6.Turn the telephone Base so the back panel is facing you. Insert either end of the
7.Insert the other end of the cable into the jack on the AC adapter labeled PHONE.
8.Insert one end of the
9.Insert the other end of this line cord into a telephone wall outlet jack.
10.Plug the AC adapter into an available, unswitched electrical wall outlet.
11.Once your telephone is connected, remove the plastic overlay by hooking the tabs on the overlay into the recessed slots located on both sides. The overlay is easiest to insert when; the left or right side tabs are inserted first, and the middle of the overlay is slightly bowed to allow for insertion of the other tabs.
12.Place the Cordless Handset on the Base Unit.
CHARGING THE BATTERY
The rechargeable Nickel Metal Hydride battery must be fully charged before using the phone for the first time. It is recommended that that battery pack be charged for approxi- mately 15 - 20 hours, without interruption, before use.
To charge the battery, place the Handset, keypad down, in the base unit. Make sure the “Charge” LED on the base lights. If the LED does not light:
1.Check to see if the AC adapter is plugged in
2.The AC adapter is NOT plugged into a switched outlet,
3.The Handset bottom is making good contact with the Base Unit charging contacts.
1
