Teledyne 200EH/EM

Teledyne API - Model 200EH/EM Operation Manual Getting Started

Firmware fully

booted

The revision level of the firmware installed in your

analyzer is briefly displayed

The startup process may hesitate at this point if the

Ethernet option is installed, DHCP mode is turned on and

the instrument is not connected to a functioning network.

SOFTWARE REVISION X.X

BOOT PROGRESS [XXXXXXXX 75% _ _]

The instrument is loading

the analyzer firmware.

M100E NOX ANALYZER

BOOT PROGRESS [XXXXX 50%_ _ _ _ _]

The instrument is loading

configuration and calibration

data from the flash chip

STARTING INSTRUMENT W/FLASH : 1

System waits 3 seconds

then automatically begins its

initialization routine.

No action required.

System is checking the

firmware stored in the

instrument’s memory

SELECT START OR REMOTE : 3

START .

CHECKING FIRMWARE STATUS : 1

STARTING INSTRUMENT CODE : 1

SAMPLE SYSTEM RESET NOX=XXX.X

TEST CAL CLR SETUP

If at this point,

**FLASH FORMAT INVALID**

appears, contact Teledyne Instruments

customer service

Press CLR to clear initial

warning messages.

(see Section 3.2.3)

System is checking the format

of the instrument’s flash

memory chip.

CHECKING FLASH STATUS : 1

Figure 3-13: Front Panel Display During Startup Sequence

04521C (DCN5731)