Teledyne 200EH/EM

Operating Instructions Teledyne API - Model 200EH/EM Operation Manual

6.5. SETUP  CFG: VIEWING THE ANALYZER’S

CONFIGURATION INFORMATION

Pressing the CFG key displays the instrument configuration information. This display lists the analyzer model,

serial number, firmware revision, software library revision, CPU type and other information. Use this information

to identify the software and hardware when contacting customer service. Special instrument or software

features or installed options may also be listed here.

SAMPLE A1:NXCNC1=100PPM NOX=XXX.X

< TST TST > CAL SETUP

SAMPLE

PRIMARY SETUP MENU

CFG DAS RNGE PASS CLK MORE EXIT

SAMPLE M100E NOX

NALYZER

NEXT PREV EXIT

Press EXIT at

any time to

return to

SETUP menu

Press EXIT at

any time to

return to the

SAMPLE dis

Press NEXT of PREV to move back

and forth through the following list

of Configuration information:

MODEL N AME

SERIAL NUMBER

SOFTW ARE REVISION

LIBRARY REVISION

iCHIP SOFTWARE REVISION1

HESSEN PROTOCOL REVISION1

ACTIVE SPECIAL SOFTWARE

OPTIONS1

CPU T YPE

DATE FACTORY CONFIGURATION

SAVED

Only appears if relevant option of Feature is active.

6.6. SETUP  ACAL: AUTOMATIC CALIBRATION

Instruments with one of the internal valve options installed can be set to automatically run calibration procedures

and calibration checks. These automatic procedures are programmed using the submenus and functions found

under the ACAL menu.

A menu tree showing the ACAL menu’s entire structure can be found in Appendix A-1 of this manual.

Instructions for using the ACAL feature are located in the Section 7.7 of this manual along with all other

information related to calibrating the M200EH/EM analyzer.

04521C (DCN5731)