Telex BP-1002, BP-2002 Introduction

Introduction 1

CHAPTER 1

Introduction

WARNING: If you have a BP-1002/2002 with a 9030-7740-XXX circuit board,

you will need to obtain Revision H of this user manual.

The Audiocom®1 BP-1002 and BP-2002 are microprocessor controlled one- and

two-channel intercom beltpacks. An internal switch and jumper setting allows the

units to be used with Clear-Com®2 components, if desired. Other internal switch and

jumper settings allow the unit to be uniquely configured to the operator’s

requirements.

1. Audiocom® is a registered trademark of Telex Communications, Inc., Burnsville, MN

55337.

2. Clear-Com® is a registered trademark of Clear-Com Intercom Systems.

Contents

Main Proprietary Notice Copyright Notice Warranty Notice Customer Support Return Shipping Instructions Table Of Contents Page Introduction 1 Introduction Page Introduction 3 External Connections and Controls NOTE: The numbers refer to the callouts in Figure 1. NOTE: 4Introduction Operation 5 Operation System Power Initial BP-1002/2002 Setup Operating Modes Internal Switches, Jumpers and Adjustments Page 8Operation > Clear-Com Setup > Operation 9 Connector Pin Configurations 10 Operation Specifications Operation 11 Optional Football Modifications General Description Eliminating Mic-Kill and Call Signal Restoring Mic-Kill and Call Signal