EMG Panic Button (if wired for use in your vehicle)
1)The EMG or Panic Button can be programmed to do many things but may not be connected in your vehicle. Check with your technical department to understand what this button will control before you use it.
2)In Record mode: Press the EMG button on the transmitter, a beep will sound and the relay will be triggered at the receiver.
3)In Standby mode: Press the EMG button on the transmitter, a beep will sound, the green
Disabling the Beep Sound On the Transmitter
1)All of the audible beep signals on the transmitter can be disabled by setting the BEEP switch to the off position.
Auto Talk (if video recording equipment supports)
1)The Auto Talk feature is used to turn on the microphone whenever the video recorder is turned on. Some video record units can be triggered by other events (lights and siren being turned on etc.) and Auto Talk ensures the microphone starts recording at the same time. The transmitter must be turned on and in standby mode.
2)A +5V signal on the Auto Talk line means the microphone is off.
3)0V or ground on the Auto Talk line turns on the microphone
INSTALLATION
1.Wire the
Audio In
12 FT
Description
Power +12V DC
Video Trigger
(Ground = Transmitter On)
Left Channel (Ground to enable Inside Microphone)
Power Ground
AUX (Panic) Trigger
12V+ DC Output when EMG button is pushed
Auto Talk Trigger
5V+ DC to 0V to turn on mic
0V to 5V+DC to turn off mic
Color
Red
Blue
Yellow
Orange
Black
Brown
Revision B | Page 4 of 9 | 12/11/08 |
