Using the SetDock Utility
SetDock is copied onto your system at the time you install
the DockMate Software Installation diskette. The SetDock
utility is used in the DOS environment only. Like TI Setup,
it configures your system for use with peripheral devices. If
you are using Windows or Windows 95, use TI Setup when
you add or change peripherals. For more information on
options available on SetDock screens, refer to the table in
the Using TI Setup section of this chapter.
Running SetDock
To run SetDock from MS-DOS, go to the UTILS directory
(C:\UTILS) and type
SETDOCK.EXE
and press Enter. The SetDock main screen then appears
on your monitor.
TravelMate 5000 Dock Setup Program
Version 1.20 Dec 20 1995
Dock Configuration ’A’ Page 1 of 2
Dock Type: DockMate
Serial Ports Dock Parallel Port
Dock 9 Pin: COM1 Address: 378h
Notebook SIR: Off Extended Mode: ECP and EPP
Dock SIR (if present) Off
COM3/COM4 Addresses: 3e8/2e8
Select the type of docking station
Esc=Exit F1= Help ↑↓ Field +/- Value PgUp/PgDn
SETDOCK page 1 of 2
Using the SetDock Utility
Utilities 3-5