The First Years Swing Gate manual Attach safety brackets, Adjust width, To use, Safety Bracket

ENG CDN Hardware mounting (cont.)

9

Safety Bracket

Attach safety brackets

(Required for use at the top of stairs; optional everywhere else.) These brackets are for use on wall or surface opposite the hinge bracket.

arrow points to stairs

lower	higher
side	side

10 11

12

!WARNING:

If installing the All-Clear Swing Gate at the top of the stairs, you must attach the 2 safety brackets to serve as a mechanical locking mechanism. Make sure arrows of stair safety brackets are located to side that faces stairs, as shown in diagram 9.

1.Position mounting template against mounting surface with bottom end flush against floor as shown in diagram bk. Assure that template is straight and in alignment with hinge brackets by swinging gate closed.

2.Tape in place as shown in diagram bk.

3.Use tip of screw to mark screw holes as shown in diagram bk.

4.Remove template and drill pilot holes with 1/8 inch drill bit, approximately 2 inches deep.

5.One at a time, attach the safety brackets to the wall with the arrow pointing to the stairs as shown in diagram bl.

a. Position brackets so holes are centered over pilot holes.

b. Attach using 4 of the screws provided. Insert and secure the screws using a Phillips screwdriver.

6.Swing gate in place to ensure bumpers come to a stop and rest in safety brackets. If needed, adjust adjustment knobs for proper fit in safety brackets, as shown in diagram bm.

!WARNING:

Always check gate to ensure it stays in place.

Adjust width

Go to page 7 and follow “Pressure mounting/Adjusting width” to adjust your gate width and finish the installation.

In order for gate to swing freely when mounted at top of stairs, you must adjust the width of the gate and adjustment knobs so that the edges of the adjustment knobs touch the lower sides of the safety brackets. If needed, see diagram 9 for location of lower side.

To use

To open gate

Holding the release handle with one hand, first use your thumb to

push and slide the release button that is most comfortable for you, then lift up on the release handle. You can now swing the gate open for

walk-thru convenience.

To close gate

Swing gate shut. Lower release handle back in place. You may need to press gently against gate until you hear the handle click into place.

To verify that gate is locked, gently pull or push against it.

To temporarily remove gate for pressure mount use

The All-Clear Swing Gate can be easily removed from the brackets for use as a pressure mount gate in another room. To temporarily remove gate, simply open the gate and press the hinge pin release slider down to lower hinge pin on top of gate. Lift gate up and out of brackets. Then follow “Pressure mounting/Adjusting width” instructions.

NOTE: In pressure mount mode, gate no longer swings open.

IMPORTANT: The gate should be checked periodically for general condition with particular attention to the security of the attachments and operation of locking devices.

6