CONTINUED FROM PREVIOUS PAGE
B.NEVER PICK UP A FLAMING PAN - You may be burned.
C.DO NOT USE WATER, including wet dishcloths or towels - a violent steam explosion will result.
D.Use an extinguisher ONLY if:
1.You know you have a Class ABC extinguisher, and you already know how to operate it.
2.The fire is small and contained in the area where it started.
3.The fire department is being called.
4.You can fight the fire with your back to an exit.
READ AND SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS- Hoods
This Thermador ventilating hood is operated by a solid state motor speed control which allows infinite control of motor speeds for selection of air exhaust and sound level.
The ventilator should be turned on 5 minutes before cooking in order to draw the currents of air upward through the hood. That way when heat, smoke, moisture, grease and cooking odors arise, they will be carried upward and forced outside, thereby minimizing their drift into other rooms.
Drafts across the cooking surface from an open window, door etc., may cause the escape of heat, moisture, grease and cooking odors from the hood. Such drafts should be prevented whenever possible.
The best job of ventilation in the kitchen is done when the only air currents are those created by the ventilator itself.
CLEANING INSTRUCTIONS
For maximum efficiency, clean filter and hood regularly. Do not allow grease to accumulate on the hood or the ventilator surface.
1.To Clean the Filter – Remove the filter by applying slight thumb pressure on the sides of the clips, and pulling the filter out by the top of the filter frame. Filter may be washed in the dishwasher or washed in warm soapy water, drain and dry before installing.
2.To Clean Motor and Blade Unit – First remove filter and
DISCONNECT
PLUG. Loosen | BLOWER ASSEMBLY REMOVAL | |||
nut and remove |
|
|
| |
blower | using | Remove |
| Remove |
handle, see | figure | Nut |
| Blower |
|
| Using | ||
below. Wipe entire |
|
| ||
|
| Handle | ||
unit clean | with a |
|
| UNPLUG! |
damp cloth. Do not |
|
| ||
|
|
| ||
use a dripping wet |
|
|
| |
cloth as water may |
|
|
|
enter the motor and cause damage. Do not remove blower wheels.
3.To Reinstall Unit – reverse the procedure in steps 1 and 2.
4.To Clean Hood Surface – Use only mild soap or detergent for cleaning all hood surfaces. Dry surfaces with a cloth for maximum luster.
Enamel Surface – Use only mild soap or detergent for cleaning all hood surfaces. Dry surface with clean cloth for maximum luster.
Stainless Steel Surface – The stainless steel used in the manufac- ture of these hoods is resistant to most stains and surface rust when cleaned and protected with a stainless steel cleaner/polish. Apply this type of product regularly according to manufacturer’s directions to maintain appearance and protect the finish from surface damage.
Filter Cleaning – Pull open the housing door and remove the filters. Filters may be washed in hot sudsy water, or sprayed with a household kitchen cleaner (such as Fantastik®), then rinsed with hot water, or washed in the dishwasher. Replace after they are dry.
CONTINUED ON NEXT PAGE