Custom front panel
Prepare and attach custom front panel
6
Test the installation
You can attach your own front panel for this warming drawer.
This front panel must: have a handle
have the dimensions shown on the included template have a thickness of 3/4" (19 mm) at least
have all edges finished
stand a temperature of 158 ºF (70 ºC).
. . .
4. Drill pilot holesBe. careful not to drill all the way through the pan Pilot holes should only be 7/16" (11 mm) deep.
5.
6.
7.Attach your own handle.
8.Attach the prepared custom front panel from behind with four wood four washers accordind to figure 1.
Turn on the PLATES setting. Signal light begins to flash immediately. Dis indicates 0:30. Close the drawer. Signal light stops flashing after 10s to five minutes. Open the drawer. The air in the drawer should be warm. place hand directly on drawer bottom, but you should be able to feel coming off the glass.
8