Timex 75330T manual Basic Setup, Product Specifications, Atomic Clock, AM / PM Indicator, Day/Date

BASIC SETUP

1.Battery Installation - BEGIN WITH THE OUTDOOR WIRELESS SENSOR

1 BATTERYREMOVE	2	INSTALL 2 “AA”
COMPARTMENT		BATTERIES.
COVER		alkaline or lithium

Wireless Sensor

Atomic digital clock

3	Remove the battery compartment cover on the
	back of the clock and install 6 FRESH “AA” Alkaline

(only) batteries as shown here

2.Initial Setup - once the batteries are installed, the clock will power up. The display will appear as follows:

Atomic Clock			AM / PM Indicator
Signal Indicator
Time Zone Indicator	EST
(Defaults to Eastern Standard Time)
			Outdoor Temperature
			with Trend Arrow
			(Defaults to Fahrenheit)
Day/Date			Indoor Temperature
Calendar			with Trend Arrow
	Moon Phase	Outdoor Temperature Sensor
	Indicator
		Signal Indicator

The clock will initially set itself to the correct time and date, defaulting to EST (Eastern Standard Time). It will also begin displaying the temperatures. The clock will begin searching for the Atomic signal.

Note: The clock will adjust for daylight saving time, even if it is unable to receive the WWVB signal

After the clock acquires the Atomic signal (this may take 24-48 hours) the time, date and daylight saving time changes will update automatically, giving you maintenance-free operation and accuracy to the split second

Product Specifications

Indoor Temp. Range = 32°F to 140°F (0°C to 60°C) *NOTE: indoor unit should not be placed in conditions Outdoor Temp. Range = -40°F to 158°F (-40°C to 70°C) under 32˚F

Atomic Clock Frequency = WWVB 60Khz 433Mhz - Radio Signal Synchronizes daily in optimal conditions

100' (30m) Radio Frequency Transmission Range

Power Requirements = (8) "AA" Alkaline Batteries

BATTERY SAFETY:

Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.

LIMITED ONE YEAR WARRANTY - Chaney Instrument Company warrants that all products it manufactures to be of good material and workmanship and to be free of defects if properly installed and operated for a period of one year from date of purchase. REMEDY FOR BREACH OF THIS WARRANTY IS EXPRESSLY LIMITED TO REPAIR OR REPLACEMENT OF DEFECTIVE ITEMS. Any product which, under normal use and service, is proven to breach the warranty contained herein within ONE YEAR from date of sale will, upon examination by Chaney, and at its sole option, be repaired or replaced by Chaney. In all cases, transportation costs and charges for returned goods shall be paid for by the purchaser. Chaney hereby disclaims all responsibility for such transportation costs and charges. This warranty will not be breached, and Chaney will give no credit for products it manufactures which shall have received normal wear and tear, been damaged, tampered, abused, improperly installed, damaged in shipping, or repaired or altered by others than authorized representatives of Chaney.

2 7