Placement of the Clock:
Place the clock in an area free of dirt and dust. To help ensure an accurate indoor temperature measurement, be sure to place the main unit out of direct sunlight, and away from any heat sources or vents in your home.
This clock may be hung on a wall using the integrated
Placement of the Outdoor Sensor:
The wireless temperature sensor MUST BE PLACED OUTDOORS to capture and relay the outdoor temperature to the clock display unit. You may place your wireless temperature sensor outside up to 100 feet (30m) from the clock, as shown.
The sensor is water resistant and is designed for outdoor use. However, to extend the life of the product, place it in an area protected from harsh weather elements. To ensure an accurate temperature reading, be sure the sensor is out of direct sunlight and away from any heat sources.
164 Feet100’MaximumFeet
(50 meters)
Wireless Signal Reception Icons
The main unit has signal reception icons in the outdoor temperature display area and near the clock display. For the first installation, the bars running to indicate the signal reception. Once received the signal, the temperature will be displayed. If there are a low number of “bars” present, you may experience the signal antenna. “ “ flashing to indicate no outdoor temperature receive or inaccuracy. In either case, you may need to relocate one or both of the units. If most or all 4 of the “bars” are present, wireless reception is good and no action is required.
NO | Strong |
Reception | Reception |
SETTING THE CLOCK MANUALLY
Up | SET |
|
Arrow | |
SET | |
Down
Arrow
“Set” to confirm
manual settings
Back of Clock
1)SETTING YOUR TIME ZONE
a)Press and HOLD the SET button until you see the selection of seven time zones
b)Press the UP (s) ARROW repeatedly until you reach your time zone, then press SET.
2)TURNING ATOMIC CLOCK FEATURE ON/OFF
NOTE: You do NOT need to turn off the atomic clock to set the time manually. Once the clock receives the signal, it will adjust the clock accordingl. However, you may choose to deactivate the atomic clock feature completely if you prefer to manually control the clock or if you live in a remote area that does not readily receive the atomic signal. As long as the atomic clock is ON, it will automaticlly adjust itself to the correct time, overriding your manual setting.
Press the UP (s) ARROW to or DOWN (t) ARROW buttons to turn OFF Atomic signal. This will stop the clock from searching for the Atomic radio signal, and allow you to set the clock manually.
3)SETTING THE CLOCK & CALENDAR
a)Press the UP (s) ARROW to turn DST (Daylight Saving Time) function on or off. Press “SET” to confirm.
b) | The HOUR will flash | Press the UP (s) ARROW repeatedly, | Press “SET” |
|
| until the correct hour (AM or PM) is | to confirm |
|
| displayed. |
|
|
|
|
|
c) | The MINUTE will flash | Press the UP (s) ARROW repeatedly, | Press “SET” |
|
| until the correct minute is displayed. | to confirm |
d) | The YEAR will flash | Press the UP (s) ARROW repeatedly, | Press “SET” |
|
| until the correct year is displayed. | to confirm |
e) | The MONTH will flash | Press the UP (s) ARROW repeatedly, | Press “SET” |
|
| until the correct month is displayed. | to confirm |
f) | The DATE will flash | Press the UP (s) ARROW repeatedly, | Press “SET” |
|
| until the correct date is displayed. | to confirm |
DAY OF THE WEEK AND MOON PHASE WILL UPDATE AUTOMATICALLY AS YOU SET THE DATE
e) The °F will flash | Press the UP (s) ARROW to change | Press “SET” |
| between °F and °C. | to confirm |
|
|
|
4 | 5 |
