Tissot G15, G10 manual Retrograde model, Stop Time readout

Quartz Chronographs G10/G15

*

Retrograde model

Usage / Settings

Models with a screwed crown

To ensure even better water-resistance, some models are fitted with a screwed down crown. Before setting the time or date, you must first unscrew the crown to position IB, before pulling it out to position II or III.

Important: After every operation, the crown must be screwed back down firmly to protect the seal integrity of the watch. Setting the time

Pull the crown out to position III and turn it clockwise or anticlockwise to set the desired time. Synchronize the small seconds hand at the 6 o'clock position with an official time signal (radio/TV/Internet) by pulling out the crown to the second notch; the hand will then stop. Once the time has been synchronised, push the crown back down into position I (and tighten it back down on models with a screwed down crown).

Winding

Quartz chronographs never need to be wind.

Fast correction of the date

Pull the crown out to position II and turn it anticlockwise until the correct date is displayed.

Resetting the counters

The counters must be zeroed before starting timing. If necessary, proceed as follows:

1 Zero the 60 minute counter hand: - Crown in position II, pusherB

2 Zero the 30 second retrograde counter hand: -Crown in position III, pusher A

3 Zero the 5 minute retrograde counter hand: - Crown in position III, pusher B

Simple timing

The «simple timing» function is no different to that on a standard chronograph, but the retrograde counter hand turns anti-clockwise, from 9 o/c to 3 o/c.

1 START

2 STOP (Time readout)

3 Reset counters to zero

NB: Before each timing operation, the chronograph hands must be at their start points. If necessary, see paragraph RESETTING THE COUNTERS.

Comment: All the timing functions are available while the crown is pressed into position I.

w w w. t i s s o t . c h 4/5 134 _ EN / 05 . 07