English
8. ALARM:
A. To set the Alarm time: Press the Alarm button briefly. The word “Alarm” will flash on the display.
(Figure 5) Press and hold the Time Set Button to set the Alarm time until a beep is heard to
confirm you have entered the Alarm Time Set mode. The hour will blink. (Figure 6) Tune Up/
Down buttons briefly to ch ange each h our or press and hold to r apidly cha nge the hour s.
“PM” will appea r for afternoo n/evening hou rs but there is n o “AM” designati on for morning
hours. Now press the Time Set button t o adjust the minutes using the Tune Up/D own buttons.
(Figure 7) The minutes will not affect the hour setting. Press the Time Set button again to save
the settings.
NOTE: Non-US models us e a 24 hour alarm format.
Figure 8 Figure 9
B. To set the Alarm to wake: Set the SongBook to th e FM or AM statio n you wish to wake t o
and that will be broadca sting during the tim e you wish to wake (or set to O ff or Aux to wake
to an increas ing beep) an d adjust the volume level accordingl y. Press and h old the Alar m
button. A beep tone wil l be heard confirming the Alarm is set to wake an d the word “Alarm”
will show on the display. The S ongBook will go int o Standby mode and th e display will show
“Standby”. (Figure 8) If the Alarm has been se t and the SongBook is in the Off positi on, the
alarm wake time will show in the upper righ t hand corner. When the alarm activates , the LCD
will light up and t he word “Alarm” wi ll flash. (Figur e 9) Should you o pt to wake to the be ep,
the beep will sound for 6 0 seconds, then pause fo r 60 seconds, then res ume for another 60
seconds. This pattern will r epeat for up to one hour or until the Alar m button is pressed.
If the alarm is set and activates but the batteries are too weak to play the radio, the beep will
sound instead, provided there is enough battery power remaining. The LCD will show an “E”
to indicate the batteries are empty. (Figure 8)
Figure 10
C. To Cancel the Alarm: When the alarm activates, press the Alarm button to cancel the alarm
and the word “Alarm” will disappear from the display, the display will flash the word “Off”(Figure
10) for several seconds, and the unit will go into Standby. Changing the source knob to another
position will cancel Standby mode. Once the alarm activates, if it is not manually turned off, the
Alarm will shut off automatically after approximately 60 minutes to preserve the batteries and
the display will say “Standby”.
6