PART DESCRIPTION
POWER SWITCH
Place this switch in the ON position and power is supplied.
Note : When not loading the tape :
The auto switch is placed in the manual mode.
When loading the tape :
| Unrecorded tape | the | auto | switch | is |
| placed in the manual mode. |
|
| ||
| Recorded tape | the | auto | switch | is |
| placed in the automatic mode. |
|
| ||
AUTO SWITCH |
|
|
|
| |
When using a | or an external | ||||
timer | , set this switch | to ON | (automatic mode). |
Place this switch in the OFF position (manual mode) for the tape deck operation
MESSAGE OMIT SELECTOR
These selectors function only when placing the auto
switch | in the automatic mode. If wishing to omit |
one or more of the recorded messages (No.1 through
No.9), depress this switch(es).
TAPE COUNTER, RESET BUTTON
This indicates how far the tape has travelled. Depress the reset button to reset the tape counter display to "000".
CASSETTE RECEPTACLE
Load the cassette tape with the exposed tape face down, and then close lid.
Note : Be sure to depress the eject button after the
auto switch is turned to the manual mode. Ejecting the tape in the automatic mode may lead to malfunction of the deck.
EJECT BUTTON
Depress this button to open lid of the cassette
receptacle. (Do not depress this button while the
cassette tape is travelling.)
MESSAGE COUNTER
This indicates the message number while its announcement is being made. The message number to follow next is indicated when the tape motion stops.
TAPE DECK CONTROLS and LED INDICATIONS
These controls function only when placing the auto
switch in the manual mode.
Rewinds the tape at high speed. Advances the tape at high speed. Advances the tape for playback, and the green LED illluminates during playback. The tape stops travelling automatically after each announcement has been finished.
Depress this button to stop the tape motion or to release the recording mode.
First of all, depress this button before starting
recording. Thereafter, also depress after recording of each message is finished. The tape continues to travel for approximately 7 seconds to
make an unrecorded sound section on the tape even after the recording is finished and this button is depressed. The red LED of this button flashes during tape travel and it illuminates
instead of flashing when the tape motion stops.
After placing in the recording standby mode by depressing the REC SPACE button, depress this switch and record with the remote microphone
TIMER SWITCH
This functions only when placing the auto switch in the automatic mode. Place this switch in the OFF position when an external timer is used.
PHONES (HEADPHONE) JACK
Accomodates stereo or monaural headphone. Insertion of the headphone into this jack cuts line output out.
Note : When inserting the headphone into this jack,
output signal from the line out | is not fed. |
— 4 —